SMRELIEFSWITCH command

Converts corner reliefs.

Icons:

Description

Converts corner reliefs to circular, rectangular or V-shaped reliefs. Converts bend reliefs to smooth, round, rip or rectangular bend reliefs. This command also allows to change the parameters of existing corner reliefs.

Options within the command

V-type: Switches the selected corner reliefs to V-type.; Note: Only corner reliefs which are related to exactly two bends can be switched to v-type.

RECtangular

Switches the selected bend reliefs/ corner reliefs to rectangular.


Bend	Corner

CIrcular: Switches corner reliefs to circular.; Note: Only corner reliefs which are related to exactly two bends can be switched to circular reliefs.

relief Diameter: Specifies the relief diameter.

Auto: Uses the minimal diameter.

REference point: Specifies the reference point for the relief.

Middle: The reference point is at the intersection of the bend lines.

Corner: The reference point is at the circular arc through the base points of the corresponding rectangular reliefs.

from Global settings: Uses the value from global sheet metal settings of document.

SMooth: Switches the selected bend reliefs to smooth.; Note: Smooth bend reliefs can be applied only if the current relief type is Rectangular. If not, BricsCAD displays the message: Unable to build relief geometry for this configuration.

RIp: Switches the selected bend reliefs to rip.; Note: Rip bend reliefs can be applied only if the current relief type is Rectangular. If not, BricsCAD displays the message: Unable to build relief geometry for this configuration.

ROund: Switches the selected bend reliefs to round.; Note: Round bend reliefs can be applied only if the current relief type is Rectangular. If not, BricsCAD displays the message: Unable to build relief geometry for this configuration.

relief EXtension: Specifies the relief extension.

Auto: Keep the current extension.

Entire model: All corner or bend reliefs in all sheet metal parts in the model will be switched to the specified type using the specified parameters.; Note: If this option is chosen as the response to the initial prompt, all corner reliefs switch to V-type.

Relief extension illustration

Rectangular and V-type reliefs:


	Extension Bend

Circular reliefs:


	Minimal extension Diameter of the relief in the unfolded representation Note: Reference to determine the center of the relief. Bend

V-type reliefs:


	Extension Bend