SMFLANGEBEND command

Allows to bend an existing flange along a line, obeying the k-factor for given bend radius.

Icon:

Options within the command

New line: Allows to draw a line to define the bend location.

Angle: Specifies the bend angle.

Radius: Specifies the bend radius.; Note: The default bend radius is defined by the Modeling/Bend Radius property in the Mechanical Browser for Sheet Metal.

Switch sides: Allows to move the part of the flange on the other side of the line or edge.

Toggle bend extents: Toggles between keeping the bend extents (1) or not (2). Default is not.

ACcept: Creates the bend at the current angle and radius.